6.3.1. Possible malfunctions of cardan transfer and ways of their elimination
|
|
|
|
Possible malfunctions of cardan transfer and ways of their elimination
|
|
|
Cause of defect
|
Way of elimination
|
|
Knock in cardan transfer at sharp change of the movement of the car or at gear shifting
|
|
|
Wear of bearings and thorns of crosspieces in hinges
|
To check a radial gap in bearings of hinges and if it exceeds 0,10 mm, to replace a crosspiece and bearings
|
|
Fastening of a shaft to a flange of the leading gear wheel of the back bridge weakened
|
To tighten fastening the set moment
|
|
Vibration of cardan transfer
|
|
|
The balancing plate is lost
|
To make dynamic balancing of a shaft
|
|
The shlitsevy fork of an intermediate shaft is incorrectly established
|
To establish a shlitsevy fork in one plane with the sliding fork
|
|
Fastening of an intermediate support to a cross-piece the Raised beating of the sliding fork in the transmission extender weakened
|
To tighten fastening
|
|
Wear or breakage of one of hinges
|
To originally turn a fork on vents on a corner 180 ° and to check whether the beating will decrease. If it does not decrease, then to replace worn-out details. When replacing a shlitsevy fork dynamically to balance a shaft
|
|
Breakage or damage of a flange of the leading gear wheel of the back bridge
|
To replace the hinge
|
|
The driveshaft pipe is bent or removed
|
To replace a flange
|
|
Fastening of a shaft to the back bridge weakened
|
To examine a shaft, to check its beating and if it exceeds 0,8 mm, to align it, at the same time its beating has to be no more than 0,6 mm in any point on length. To balance a shaft dynamically. To tighten fastening
|
|
Malfunctions which come to light at survey
|
|
|
Provorachivaniye of a cap with a cuff concerning a bearing glass (violation of tightness of the hinge)
|
To replace a crosspiece assembled with the bearing. To balance transfer
|
|
Provorachivaniye of a bearing glass in fork openings
|
To replace worn-out details, to balance transfer
|